4-20 mA/V Calibrator with Loop Diagnostic (Includes Carrying Case)
The BEST Milliamp Calibrator on the Market
The Practical Instrument Electronics (PIE) Model 532 is the best tool for calibration, test, and diagnosing process loops. The Model 532 brings all the features you would expect from a loop calibrator and times new romanaving new ones. Make adjustments with the EZ-Dial™ knob or test limits with the Dual Action EZ-Check™ switch. Powerful ramping functions are only a button away on the Model 532. Save potentially hours of troubleshooting time on problem loops with the Model 532’s unique Loop Diagnostic Mode, only available at PIE! In Loop Diagnostic Mode, the loop current, voltage, impedance, AC voltage, and mode of operation are all displayed simultaneously eliminating the need of a DMM connection. Loop diagnostics is available in every mode of operation and truly is a diagnostic monitor, as parameters are continuously updated in real time. The smart diagnostic tool even indicates the most likely cause of loop failure! Loop Diagnostic features the ability to measure ground fault error caused by faulty wiring, flooded conduit and corrosion bridges.
True ±0.012% of reading accuracy
Source and Read 0.000-24.000 mA
Simulate 2-Wire Transmitters
Power 2-Wire Transmitters and Read 0.000-24.000mA
Display current in mA or -25.00-125.00 % of 4-20 mA
Read 0.00 to ± 30.00 VDC with 4X over range ability
Source 0.000 to 24.000 VDC with up to 20mA output
Direct Calibration 1.000V to 5.000V
Auto Step or Ramp
Selectable step sizes, time in-between steps & soak time
Stop watch like EZ-Check™ switch
Full 5 Digit Display
Uses 1 – 9Volt alkaline battery
Superior battery life of 40 hours under typical continuous usage
Easy access to battery compartment
240 VAC Tolerant
HART® protocol compatibility mode
Power on selectable 250Ω resistor in series with the output for compatibility with HART® protocol enabled devices.
AC adaptor, carrying case, and Test Data available
NIST Traceable Calibration Certificate included FREE