Curve Tracers Other Types of Equipment : Tektronix 371A

The 371A Programmable Curve Tracer, the industry leader in high power curve tracers is used for testing a wide variety of power semiconductors. It performs DC parametric characterization of thyristors, SCRs, IGBTs and power MOSFETs. The high voltage collector mode permits testing the Off-Characteristics of a device up to 3,000 volts. The pulsed high current collector mode provides output current pulses greater than 400 amps peak for testing On-Characteristics. It also permits high power testing up to 3,000 watts. In the R&D lab, the 371A is used for characterization of new designs of power devices, extraction of SPICE parameters, failure analysis and data sheet generation.

In manufacturing test, the 371A is used to verify device quality and process monitoring.

The 371A is used for incoming inspection to verify power device performance and perform failure analysis.

Interactive Programmable Control Interactive control of all measurements can be done from the full featured front panel or over the GPIB. Operating parameters can be adjusted and stored and recalled using several storage methods including the 371A nonvolatile memory, the built-in MS DOS�compatible floppy disk or to an external controller.

Automated Cursor Measurements The 371A provides three cursor measurement modes. The Dot cursor provides direct screen readout of voltage, current, gm or DC beta at any point. The Window cursor can be positioned between two curves to measure small signal beta or gm, and can also be used for visual go/no-go tests. The Function Line cursor provides screen readout of a slope or intercept value.

Sweep Measurement Mode In the sweep measurement mode, the 371A will automatically construct a family of curves while stimulating the device with low duty-cycle pulses. With this capability, power curves can be displayed without excessive heating of the device.

Test Fixturing A test fixture is a standard accessory that provides safe device enclosure to ensure operator protection during measurements. The test fixture accommodates standard A1001 through A1005 adapters with Kelvin sensing, 3-Pin adapters without Kelvin sensing and the A1023 and A1024 surface mount adapters. Also see TEK 370/370A/370B/371B.

• 制造商: Tektronix
• 模型: 371A

联系我们的更多信息