The only hipot and 4 wire resistance meter on the market. The Hybrid 2000 Analyzer is a complete dielectric testing solution with AC
Hipot, DC Hipot, Insulation Resistance and DC Resistance testing capability.
The Hybrid 2000 combines these four test modes with eight HV scan channels
for fast multi-point testing. The Hybrid 2000 has Open/Short Circuit detection
for establishing proper device connection and Load/Line regulation to ensure
measurement integrity. The digital display and user friendly controls allow
test parameters and limits to be set without the high voltage activated.
Perform hipot & contact resistance testing with one instrument
Automatic switching for multi-point testing
Monitor resistance while checking intermittent connections
Insulation resistance testing up to 5000V DC
Features
New and improved DC resistance 2 or 4 wire
Substep function allows for secondary tests to be performed after failure
DC resistance temperature compensation
DCR Balance
AC Dielectric Withstand Voltage 50 to 5000VAC, Current to 30mA
DC Dielectric Withstand Voltage 50 to 6000VDC, Current to 10mA
IR Measurements from 1MΩ to 50GΩ, Test Voltage 50 to 5000VDC
DC Resistance Measurements from 50mΩ to 100kΩ
Real and Total Current Measurement
Built-in Scanner with 8 HV Output Channels for Multi-Point Testing
Programmable Hi/Lo Limits for Pass/Fail Testing
Ability to Perform Multiple Tests in Sequence
Internal Storage and Recall of 50 Test Setups, 20 Steps Each
Programmable Ramp, Dwell, Test and Fall Times
Open/Short Circuit Check to Ensure the Device is Connected
Pause Mode Allows the Operator to Change Device Connection & Continue
Front Panel Lockout Prevents Changes to the Test Setup
Automatic Offset to Zero Out Residual Current
Ground Fault Interrupt (GFI) for auto shutdown if current imbalance
>0.5mA
